Installation Instructions
FUNCTIONS
0
0 0
8 O O O O O 8
o dJ
0
0
(E)imDIDD))))jDIDDIDDID
a,
ov 0 (J)mID
0
~
0~
o@
0
@
SAFETY
Height Adjustment (seven levels).
15. Make sure your work platform is sufficiently sturdy to do the specific job at hand
a. Turn the height adjustment knobs counter-clockwise on each leg to loosen (fig. 1).
b. Push the elevating swing bar back with your foot to disengage the two hooks and adjust
the height of the bench upwards (fig. 2) or downwards (fig. 3).
c. Use the elevating swing bar to ensure the two hooks are re-engaged into the two elevating
rods’ adjustment holes.
d. Turn the height fixing knobs clockwise on each leg to tighten (fig. 4). Note: Ensure the
height fixing knobs are tight before using the workbench.
16. Properly anchor blade for job being done.
17. Use correct blade for job being done.
18. Think Safety. Safety is a combination of operator awareness, common sense and
alertness at all times.
PARTS LIST
PART # DESCRIPTION QTY
PART # DESCRIPTION QTY
4 pcs
2
1 pcs
7
SMALL TABLE DOG
1
BENCH TOP WITH SLIDING BAR
4 pcs
3
2 pcs
8
LEG FEET
ELEVATING ROD WITH TILT ADJUSTER
4 pcs
4
1 pcs
9
M6X35 BOLT
CROSS BAR
4 pcs
5
1 pcs
10
M6X12 BOLT
LEG FRAME
8 pcs
6
4 pcs
11
M6 NYLON NUT
LARGE TABLE DOG
8 pcs
2 pcs
12
M6 WASHER
HEIGHT FIX KNOB
FIG 2
FIG 3
FIG 1
FIG 4
1
2 3
Tilt Angle Adjustment (four levels).
a. For normal use, the bench top will be set horizontal, however the top can also be adjusted
to 25°, 50° and 80°.
b. Ensure that the tilt adjustment knobs are completely unscrewed.
c. Push the two adjustment knobs in simultaneously and tilt the bench top until the knobs
engage into the next set of preset guide holes (fig. 5).
d. Turn the tilt adjustment knobs clockwise to tighten the bench top and hold the desired
position.
Note: Ensure the tilt adjustment knobs are tight before using the workbench. Use the
preset guide holes only.
9
4
5
6
10
FIG 5 FIG 6 FIG 7
7
11
a. To adjust the bench top, pull up both levers on each sliding bar and slide forwards or
backwards as desired (fig. 6).
b. Ensure that the mechanism is securely engaged in the holes in both sliding bars.
c. The support table extension arms can be swung in and out of position to best suit the
needs of the work piece being held in place (fig.7).
Bench Top Adjustment
8
12
Page 5 Page 2