Installation Instructions

ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS
0-----:~~
0
o--- -t11
0
0
"i!H"'-----t----0
'---l-,l-=,,-\------r-----0
8
7
5
1
2
10
4
6
12
11
3
1. Attach four leg feet (8) to the leg frame (4).
2. Attach cross bar (3) to the two elevating rods (2) with M6 x 35 hex bolts (9), M6 Nylon
nuts (11) and M6 washers (12). Make sure the seven pre-drilled holes on both elevating rods
are on the opposite side and the adjusting knobs are on the outside of the assembly.
3. Push the elevating swing bar backwards and insert the elevating rod assembly into the frame
tubes ensuring that the latches on the swing rods fit into the holes on the elevating rods.
4. Use height fix knob(6) to tighten elevating rod (2) to keep the safe situation.
5. Lay the bench top (1) onto the top of the elevating rod assembly. Ensure the frame of the
bench top sits outside the tops of the legs. Attach using M6 x 12 bolts (10), M6 safety hex
nuts (11) and M6 washers (12).
6. The Table dog (5) can be inserted into the top channels. Pull the Table dog (5) up and turn it
around to adjust the angle of the clamp, as required.
7. The small table dog (7) can be inserted into the side channels, as required.
4
3
x2
x2
x2
Page 4
Page 3