Installation Instructions

Customer Service:

1-888-229-2874

69MF143ANG

1/2" PEX Angle Crimp Tool

How to use:

1. Cut tubing end squarely.

Check for and remove any

burrs.

2. Slide crimp ring over end

of tubing. Insert tting into

end of tubing until it stops.

Position the crimp ring

1/8" to 1/4" from the end

of the tubing and over the

ribs of the tting.

4. Place the crimping end of

tool around the crimp ring.

Push the handles together

rmly until the jaws are

completely closed. Repeat

step 3 to release the tool

from the crimped ring.

5. Check for proper crimp

with the Go/ No-Go

gauge. Pressure test the

PEX tubing and inspect

before burying or normal

use.

3. To open the jaws: In a

continuous motion, pull

the moving handle apart,

down, then back towards

the stationary handle.

Moving

handle

Stationary handle

PAGE 1
69MF143ANG 1/2" PEX Angle Crimp Tool How to use: 1 2 3 Moving handle Stationary handle 1. Cut tubing end squarely. Check for and remove any burrs. 4 4. Place the crimping end of tool around the crimp ring. Push the handles together firmly until the jaws are completely closed. Repeat step 3 to release the tool from the crimped ring. Customer Service: 1-888-229-2874 2. Slide crimp ring over end of tubing. Insert fitting into end of tubing until it stops.
PAGE 2
69MF143ANG PEX Go/No-Go Gauge Please check every ring with the Go/No-Go Gauge after crimping to ensure a proper connection. How to use: 1. Slide the correct slot on the gauge around the crimped ring. 2. If the ring does not fit into the slot at all, then the crimp is a “No-Go”. Adjust the crimping force on the tool and re-crimp the ring. 3. If the ring slides into the slot and stops in the “Go” range, then the crimp is good. 4.