Installation Instructions

Customer Service:

1-888-229-2874

69MF14C-I_08/23/12

69MF14C

1/2" & 3/4" PEX Crimp Tool

How to use:

1 2

1. Cut tubing end squarely.

Check for and remove any

burrs.

2. Slide crimp ring over end

of tubing. Insert tting into

end of tubing until it stops.

Position the crimp ring

1/8” to 1/4” from the end

of the tubing and over the

ribs of the tting.

3. Place the crimping end of

tool around the crimp ring

and press the handles

together.

4. Check for proper crimp

with the Go/ No-Go

gauge.

PAGE 1
69MF14C 1/2" & 3/4" PEX Crimp Tool How to use: 1 1. Cut tubing end squarely. Check for and remove any burrs. 2 2. Slide crimp ring over end of tubing. Insert fitting into end of tubing until it stops. Position the crimp ring 1/8” to 1/4” from the end of the tubing and over the ribs of the fitting. 3 3. Place the crimping end of tool around the crimp ring and press the handles together. Customer Service: 1-888-229-2874 4 4. Check for proper crimp with the Go/ No-Go gauge.
PAGE 2
69MF14C PEX Go/No-Go Gauge How to use: 1. Slide the correct slot on the gauge around the crimped ring. 2. If the ring does not fit into the slot at all, then the crimp is a “No-Go”. Adjust the crimping force on the tool and re-crimp the ring. 3. If the ring slides into the slot and stops in the “Go” range, then the crimp is good. How to adjust the crimp force: 4. If the ring slides all the way into the slot, then the crimp ring is compressed too small and is a “No-Go”.