Installation Instructions

2
1. Slide the correct slot on the
gauge around the crimped
ring.
2. If the ring does not t into
the slot at all, then the crimp
is a “No-Go”. Adjust the
crimping force on the tool
and re-crimp the ring.
3. If the ring slides into the slot
and stops in the “Go” range
at least at one point, then
the crimp is good. The ring
will not t the go range all the
way around it.
4. If the ring slides all the way
into the slot, then the crimp
ring is compressed too small
and is a “No-Go”. Remove
the ring and adjust the
crimping force on the tool.
3 4
PEX Go/No-Go Gauge
How to use:
Customer Service:
1-888-229-2874
69MFGONO-I_09/14/15
69MFGONO