Use And Care Manual

Page 10
OPERATION
The direction of rotation of the bit is
reversible and is controlled with a selector
located above the trigger switch. With the
drill/driver held in normal operating position:
Position the direction-of-rotation selector to
the left of the tool for forward rotation.
Position the direction-of-rotation selector to
the right of the tool for reverse rotation.
Position the direction-of-rotation selector in
the center to lock the tool off.
NOTICE: To prevent gear damage, always
allow the drill/driver to come to a complete
stop before changing the direction of
rotation.
NOTICE: The drill/driver will not run unless
the direction-of-rotation selector is engaged
fully to the left or right.
LED WORKLIGHT (FIG. 5)
The LED worklight, located on the base
of the cordless drill, will illuminate when
the trigger switch is depressed. This
provides additional light on the surface of
the workpiece for operation in lower light
situations. The LED worklight will turn off
when the trigger switch is released.
ELECTRIC BRAKE
To stop the tool, release the trigger switch
and allow the chuck to come to a complete
stop. The electric brake quickly stops
rotation. This feature engages automatically
when you release the trigger switch.
INSTALLING THE BELT CLIP
(FIG. 6)
1. Align the rib of the belt clip with the hole
on the base of the drill.
2. Insert the screw and tighten the screw
securely with a screwdriver.
REMOVING THE BELT CLIP
1. Use a screwdriver to loosen the screw
that attaches the belt clip to the drill.
2. Remove the screw and the belt clip.
FIG. 5
LED
Worklight
FIG. 6
Belt clip