Use And Care Manual

Page 9
ASSEMBLY
TO ATTACH BATTERY PACK
(FIG. 1)
1. Lock the trigger switch on the hammer
drill by placing the direction-of-rotation
selector in the center position.
2. Align the ribs on the battery pack with
the grooves of the hammer drill, and
then attach the battery pack.
NOTICE: Make sure that the latch on the
battery pack snaps into place and the
battery pack is secured to the hammer
drill before operation.
FIG. 1
Battery-release button
Detach
Attach
TO DETACH BATTERY PACK (FIG. 1)
1. Lock the trigger switch on the hammer
drill by placing the direction-of-rotation
selector in the center position.
2. Depress the battery-release button
located on the battery pack to release
the battery pack.
3. Pull the battery pack out and remove it
from the tool.
INSTALLING BITS (FIG. 2)
WARNING:
Disconnect the
battery pack from tool before making
any assembly, adjustments or changing
accessories. Such preventive safety
measures reduce the risk of starting the
tool accidentally.
1. Lock the trigger switch on the hammer
drill by placing the direction-of-rotation
selector in the center position.
2. Rotate the chuck sleeve
counterclockwise when viewed from
chuck end, and open the chuck to the
approximate drill-bit diameter.
3. Insert a bit up to the drill bit flutes for
small bits, or as far as it will go for large
bits.
4. Close the chuck by rotating the chuck
sleeve clockwise when viewed from
chuck end and securely tighten it by
hand.
WARNING:
Do not use the power
of the hammer drill while grasping chuck
to loosen or tighten the chuck on the bit.
A friction burn or hand injury is possible if
attempting to grasp the spinning chuck.
FIG. 2
Release
Grip
REMOVING BITS (FIG. 2)
1. Lock the trigger switch by placing the
direction-of-rotation selector in the
center position.
2. Rotate the chuck sleeve
counterclockwise when viewed from the
chuck end.
3. Remove the bit.
WARNING:
Use protective gloves
when removing the bit from the tool, or
rst allow the bit to cool down. The bit
may be hot after prolonged use.