Use And Care Manual

Page 9
DRY VACUUM OPERATION
WARNING:
BE SURE TO READ,
UNDERSTAND, AND APPLY, INFORMATION
ENTITLED ‘SAFETY INSTRUCTIONS &
WARNINGS’. DO NOT VACUUM IN AREAS
WITH FLAMMABLE GASES, VAPORS,
OR EXPLOSIVE DUSTS IN THE AIR.
FLAMMABLE GASES OR VAPORS INCLUDE
BUT ARE NOT LIMITED TO: LIGHTER
FLUID, SOLVENT TYPE CLEANERS, OIL-
BASED PAINTS, GASOLINE, ALCOHOL, OR
AEROSOL SPRAYS. EXPLOSIVE DUSTS
INCLUDE BUT ARE NOT LIMITED TO: COAL,
MAGNESIUM, GRAIN, OR GUN POWDER.
TO REDUCE THE RISK OF HEALTH
HAZARDS FROM VAPORS OR DUST, DO
NOT VACUUM TOXIC MATERIALS.
1. Verify that the cartridge filter is securely
mounted (Fig. 10). For installation
instructions see page 16.
Fig. 10
2. Insert the hose into the vacuum port
(Fig. 11).
Fig. 11
3. Push required accessories onto the free
end of the hose or the extension wand
(Fig. 12).
Fig. 12
4. Make sure the battery pack is correctly
installed (Fig. 13). For installation
instructions see page 8.
Fig. 13
5. Turn the motor on by flipping the switch to
the 'I' ON position (Fig. 14).
Fig. 14