Use And Care Manual

17
INSTALLING THE LED WORK LIGHT
1. Remove the standard umbrella nut from the
tool (1) by turning it counter clockwise
(Fig. 9).
2. Place the worklight mounting hole (2) onto the
threaded end of the tool housing (3).
3. Thread the worklight mounting umbrella nut
(4) clockwise onto the threaded end of the
tool.
NOTE: Hand tighten only.
4. To turn the LED light ON, move the switch
button (5) to the right. To turn the LED light
OFF, move the switch button to the left.
REPLACING BATTERIES IN LED
WORKLIGHT
1. Remove the worklight from the tool.
2. Remove the LED module screw (1) using a
small screwdriver (Fig. 10).
3. Lift upward on the front of the LED module (2)
and remove it from the LED worklight housing
(3).
4. While holding the LED module in one hand,
use a small screwdriver to push the two
button cells (4) out of the LED module
(Fig. 11).
NOTE: The button cells can only be removed
from one side of the LED module.
5. Install two new CR927 button cells (5) to
replace the button cells that have been
removed (Fig 12).
NOTES:
a. Make sure the "–" (small side) of the button
cells are facing upward.
b. Make sure the switch actuator (6) is still on
the switch button and tilted away from the
switch.
6. Reinstall the LED module into the LED
worklight housing.
NOTE: When placing the LED module back
into the LED worklight housing, tilt the module
to feed the switch actuator through the slot in
the top of the worklight housing.
7. When the LED module is properly reinstalled
into the LED worklight housing, fasten it in
place with the screw that was removed.
ASSEMBLY AND OPERATING
1
2
3
4
5
Fig. 9
1
2
3
Fig. 10
Fig. 11
4
Fig. 12
5
6