Use And Care Manual

Page 6
SAFETY INSTRUCTIONS
6. Do not expose a battery pack or tool
to fire or excessive temperature. Exposure
to fire or temperature above 100 °C (212 °F)
may cause explosion.
7. Follow all charging instructions and
do not charge the battery pack or tool
outside the temperature range specified
in the instructions. Charging improperly or
at temperatures outside the specified range
may damage the battery and increase the
risk of fire.
SERVICE
1. Have your power tool serviced by a
qualified repair person using only identical
replacement parts. This will ensure that the
safety of the power tool is maintained.
2. Never service damaged battery
packs. Service of battery packs should
only be performed by the manufacturer or
authorized service providers.
SPECIFIC SAFETY RULES
1. Risk of bursting. Do not present inflator
to result in output pressure greater than
marked maximum pressure of item to be
inflated. Do not use at pressure greater than
160 PSI.
2. Inspect unit for cracks, pin holes, or
other imperfections that could cause
inflator to become unsafe. Never cut or drill
holes in the inflator.
3. Make sure the hose is free of
obstructions or snags. Entangled or snarled
hoses can cause loss of balance or footing
and may become damaged.
4. Never leave an inflator unattended with
the air hose attached to the item being
inflated.
5. Do not continue to use an inflator or
hose that leaks air or does not function
properly.
6. Do not attempt to pull or carry the
inflator by the hoses.
7. Do not use inflator as a breathing
device.
8. Never direct a jet of compressed air
toward people or animals. Take care not
to blow dust and dirt towards yourself or
others. Following this rule will reduce the
risk of serious injury.
9. Protect your lungs. Wear a face or dust
mask if the operation is dusty. Following
this rule will reduce the risk of serious
personal injury.
10. Do not use this inflator to spray
chemicals. Your lungs can be damaged by
inhaling toxic fumes.
11. To reduce the risk of over inflation,
use a reliable pressure gauge periodically
during inflation. The pressure guage on the
inflator is for reference only and is therefore
not binding for exact values.
12. Allow pump to cool for ten (10) minutes
after each ten (10) minutes of continuous
use. Never block the inflating or deflating
outlets while operating.
13. For best results, your battery tool should
be stored and used in a location where the
temperature is more than 5°C (41°F) but less
than 50°C (122°F). Do not store outside.