Installation Instructions

FIG. 2

FIG. 3

FIG. 4

Page 7

WARNING:

Check and make sure there

is no sign of physical damage to the product when

unpacking. Do not use damaged product.

SETTING UP AND ADJUSTING THE

TRIPOD

1. Loosen the tripod locking knob (F). See figure 2.

2. Push down the leg connector (A) until the legs (B) are

fully extended and firmly tighten the locking knob (F).

3. Adjust the height of the tripod by releasing the

locking levers (L1 & L2) and raising the center poles

(D1 & D2) of the tripod. Lock the levers when the

tripod reaches the desired height.

NOTE: The maximum height of this tripod is 65”.

4. Loosen the twist collar (C1) and adjust the extendable

leg (B2) to level the tripod on uneven surfaces.

Tighten the collar after leveling.

ATTACHING THE CARRYING HANDLE TO

THE H-STAND

1. Place the carrying handle vertically on the stand.

2. Use two hex screws, flat washers and spring washers

to secure the carrying handle on the stand as shown

in figure 3.

ATTACHING THE WORK LIGHT HEADS TO

THE H-STAND

1. Place the H-stand on a flat surface.

2. Use the stand locking knobs, flat washers and spring

washers to secure both work light heads on the sides

of the H-stand as shown in figure 3.

3. Hang the power cable connector on the cable hook

located on the carrying handle.

ATTACHING THE WORK LIGHT ASSEMBLY

TO THE TRIPOD

1. Place the work light assembly on the top of the tripod.

Insert bottom ends of the two Hex screws into two

holes on the supporting bracket (E).

2. Use the bracket locking system (E1, E2, and E3)

to secure the work light assembly to the tripod as

shown in figure 4.

ASSEMBLY INSTRUCTIONS