Use And Care Manual

ASSEMBLY AND ADJUSTMENTS
Page 9
A Head/motor assembly
B Column assembly and table
bracket
C Table
D Base
E Chuck
F Chuck key
G Table lock handle
H Hex head bolts (4)
I Table crank handle
J Hex keys (2)
K Feed and speed handles (4)
L LED bulb
M Table adjustment wrench
N Wedge
ASSEMBLY
The column assembly (column, column support,
rack, rack collar, and table support bracket) must
be attached to the base. The table and table
support handles must be attached to the table
support bracket. The motor housing must be
attached to the column.
IF ANY PART IS
MISSING OR DAMAGED, DO NOT PLUG THE
BENCH DRILL PRESS IN UNTIL THE
MISSING OR DAMAGED PART IS REPAIRED
OR REPLACED, AND ASSEMBLY IS
COMPLETE.
Tools needed for assembly
• Adjustable wrench
• Screwdriver
• Hammer and block of wood
Column assembly to base (Fig. 3)
1. Place the column tube (1) on the base (2),
aligning the column support holes to the base
holes.
2. Install a hex head bolt (3) in each column
support hole and tighten bolts using the
adjustable wrench.
Table (Fig. 4)
1. Place the crank handle (1) onto the shaft
(2) of the table bracket so the flat of the shaft is
under the set screw (3). Tighten the set screw
WARNING:
FIG.3
1
2
3
FIG.4
FIG.5
1
4
2 3