Use And Care Manual

ASSEMBLY AND ADJUSTMENTS
Page 10
Drill press head to column (Fig. 5)
The drill press head is
heavy. To avoid injury, two people should lift
it into position.
1. Carefully lift the drill press head assembly (1)
and position it over the column (2).
2. Place the mounting opening (3) on the drill
press head over the top of the column.
Ensure the drill press head is seated properly on
the column.
3. Align the direction of the drill press head with
the direction of the base and the table.
4. Tighten the set screw (4) using a hex key.
Feed handles (Fig. 6)
1. Insert the three feed handles (1) into the
threaded openings on the feed hub (2).
2. Manually tighten handles into openings.
Note: When using the bench drill press, one or
two of the feed handles may be removed if an
unusually-shaped workpiece interferes with
handle rotation.
Speed handle (Fig. 7)
1. Insert the feed handle (1) into the threaded
opening on the speed hub (2).
2. Manually tighten handle into opening.
Mount the bench drill press (Fig. 8)
The bench drill press must be securely fastened
through the mounting holes (1) to a stand or
workbench with heavy-duty fasteners. This will
prevent the bench drill press from tipping over,
sliding, or walking during operation.
IMPORTANT: If the stand or workbench has a
tendency to move during operation, fasten the
workbench securely to the floor.
LED bulb (Fig. 9)
Insert the LED bulb (1) into the socket (2) in the
motor head assembly.
Note: LED bulb can be replaced by any 120V 8L
LED bulb if the original one runs out of its lifetime.
Install the replacement LED bulb the same way
you install the original one.
CAUTION:
FIG.6
1
2
FIG.7
2
1
1
FIG.8
FIG.9
2
1