Use And Care Manual

Page 14

ASSEMBLY AND ADJUSTMENTS

Angular "play" of the spindle (Fig. 19)

Move the spindle to the lowest downward position

and hold in place. Try to make the spindle revolve

around its axis while also moving it with a side

motion. If there is too much "play", proceed as

follows:

1. Loosen the lock nut (1).

2. Without obstructing the upward and

downward motion of the spindle, turn the screw

(2) clock-wise to eliminate the "play".

Note: A little bit of "play" is normal.

3. Tighten the lock nut (1).

To replace the belt (Fig. 20)

DISCONNECT THE

BENCH DRILL PRESS FROM THE POWER

SOURCE BEFORE REPLACING THE BELT.

Belt tension and bench drill press speed is

controlled by automatic adjustments made to the

diameter of the front spindle when the drive

handle is moved.

Note: See page 17 for information on the variable

speed function of this bench drill press.

1. Remove the screw that secures the housing

cover (1). Open the housing cover.

2. Remove the belt (2) from the housing cover if

it is broken. If it is not broken, but is too stretched

to operate correctly, work the belt off the drive

(motor) spindle (3). Then remove the belt from the

front spindle (4).

3. Replace the belt by putting a new belt over

the front spindle (4) and carefully sliding the belt

over the drive (motor) spindle (3).

DO NOT CHANGE THE

DRIVE SPEED WHEN THE BENCH DRILL

PRESS IS TURNED OFF.

FIG.19

FIG.20

WARNING: