Use And Care Manual

SAFETY INSTRUCTIONS
LASER SAFETY
The laser light beam used in this system is Class
III. These lasers do not normally present an
optical hazard, although staring at the beam may
cause flash blindness.
DO NOT STARE
DIRECTLY AT THE LASER BEAM! A
HAZARD MAY EXIST IF YOU DELIBERATELY
STARE INTO THE BEAM, PLEASE OBSERVE
ALL SAFETY RULES AS FOLLOWS:
• THE LASER SHALL BE USED AND
MAINTAINED IN ACCORDANCE WITH THE
MANUFACTURER'S INSTRUCTIONS.
• NEVER AIM THE BEAM AT ANY PERSON
OR AN OBJECT OTHER THAN THE
WORKPIECE.
• DO NOT PROJECT THE LASER BEAM
INTO THE EYES OF OTHERS.
• ALWAYS ENSURE THE LASER BEAM IS
AIMED AT A WORKPIECE THAT DOES NOT
POSSESS REFLECTIVE SURFACES, AS THE
LASER BEAM COULD BE PROJECTED INTO
YOUR EYES OR THE EYES OF OTHERS.
SPECIFIC SAFETY RULES FOR
BENCH DRILL PRESSES
DO NOT OPERATE
YOUR BENCH DRILL PRESS UNTIL IT IS
COMPLETELY ASSEMBLED AND
INSTALLED ACCORDING TO THE
INSTRUCTIONS.
1. NEVER TURN THE BENCH DRILL PRESS
ON until the table is clear of all foreign objects
(tools, scraps, etc.).
2. ALWAYS KEEP hands and fingers away from
the drill bit.
3. DO NOT drill materials that do not have a flat
surface—unless a suitable support is used
(clamp or vise).
4. NEVER start the drill press with the drill bit
pressed against the work piece.
5. MAKE SURE the table lock is tightened
before starting the bench drill press.
6. NEVER layout, assemble, or set-up any work
on the table while the drill is ON.
7. MAKE SURE drill bit is securely locked in the
chuck.
8. MAKE SURE chuck key is removed from the
chuck before turning power ON.
9. ADJUST the table or depth stop to avoid
drilling into the table.
10. ALWAYS stop the drill before removing
scrap pieces from the table.
11. USE CLAMPS or a vise to secure a work
piece to the table. This will prevent the work
piece from rotating with the drill bit.
12. DO NOT wear gloves when operating a
drill press.
13. BEFORE LEAVING THE MACHINE, SHUT
THE POWER OFF, remove the drill bit and
clean the table.
14. SET THE DRILL PRESS to the speed that
is appropriate for the material being drilled.
15. SHOULD any part of your bench drill press
be missing, damaged, or any electrical
component fail to perform properly, shut the
power OFF and unplug the drill press. Replace
missing, damaged, or failed parts before
resuming operation.
GROUNDING INSTRUCTIONS
1. IN THE EVENT OF A MALFUNCTION OR
BREAKDOWN, grounding provides the path of
least resistance for electric current and reduces
the risk of electric shock. This tool is equipped
with an electric cord that has an equipment
grounding conductor and a grounding plug. The
plug MUST be plugged into a matching outlet that
is properly installed and grounded in accordance
with ALL local codes and ordinances.
2. DO NOT MODIFY THE PLUG. If the plug will
not fit the power supply outlet, have the proper
power supply outlet installed by a licensed
electrician.
3. IMPROPER CONNECTION of the equipment
grounding conductor can result in electric shock.
The conductor with the green insulation (with or
without yellow stripes) is the equipment
grounding conductor. If repair or replacement of
the electric cord or plug is necessary,
DO NOT connect the equipment grounding
conductor to a live terminal.
4. CHECK with a licensed electrician or service
personnel if you do not completely understand
the grounding instructions, or if you are not sure if
the tool is properly grounded.
Page 5
WARNING:
WARNING: