SAFETY INSTRUCTIONS 20.Watch your balance and fowling while using your power washer. Surfaces becomes slippery when wet and ars extra slippery when using a detergent or cleaner. 21.Never operate the power washer In bare feel, sandals, or open-dost shoes. 22 When using the power washer near children, make sure they ars closely supervised by an adult to avoid injury. Meyer let a child use the power washer. keep fingers, hands, feet and any part of your hotly clear of the stream of high pressure water.
ASSEMBLY INSTRUCTIONS Pics a foot on the pad at e font of the lower frame {G) and then it the power washer unit {F} off the frame. St pressure washer (F} to he aide. Frame Assembly Natal] sl pins (AA) and thesis {1} io lower drama (3). Recurs with cotter pins (DD}, Hardware Suds: roans x2 forenoons X Xz Page install nozzle holder (M) fo lower dams (G).
ASSEMBLY INSTRUCTIONS Locking Spray Gun (before Lance installation} To lack trigger of spray gun (K}, point gun away from you and turn dial o lock (3" and ¥ position). Squeeze or pull rigger to make sure 1t is cockade. Always leave In locked position when not in use. This ensures the gun @ in “safe” mode until it Is ready for use. Tum dist o union {*127 and "8 potion) to release spray gun rigger. Mote: The trigger sock prevents trigger from being accidentally engaged.
T | ASSEMBLY INSTRUCTIONS Foam Cannon installation The forewarn cannon comes with & straw which is filtered vireo high pressure fop. if you do not sas the wires, look insole the foam cannon and chaffinch It to the high pressure top. When using fem cannon, Al it wih 8 proper formulated detergent or cleaner with a water ratio according to instructions on the container. = B0 NOT use thick or gel-Ike enteritis as they will logo the foam cannon and can cuss damages.
ASSEMBLY INSTRUCTIONS Remove wall mount and drill four 1/8" list Put spray gun (K} on power washer unit {F). holes at marked locations. Place powers washer ult {F) in place on wall mount (O} until secure. Unit will sick into stall wall mount (G) on wall with four 2 127 Pace. cabinet meting screws (BE}.
ASSEMBLY INSTRUCTIONS & Gulf forward on latches that are located on each side of wal mount hurdler inches snap in comet position, locking power washer unit io wall mount. Refer to prows washer unit {F} downstate's manual for operation instructions for the pressure washer. = Marks sure the power which s off (it will b6 off). * Underwire the power ford completely and plug o & grounded 120 volt outer. »Turn on water supply at the faucet to completely open.
= Always tacit a small area to avoid chance of damaging the surface. » When using detergent {nof inchoate, fil with & properly formulated detergent or cleaner with water ratio according o instructions on the container. Close detergent tank when done filling. »When using detergent tank, use soap nozzle to draw detergent from tank. Do NOT use wih Foam Canaan. T | = When removing the detergent tench, squeeze the clamp and remove the small hose from detergent tank. Pull the detergent tank straight out.
OPERATING INSTRUCTIONS Adjusting Soap Novels on Foam Removing Power Washer Unk from Cannon Wall Mount for Handheld Operation Twist knob 1o adjust the level of soap s * Unlock larches by pulling downward on the indicated on the top of the Foam Cannon lathes, and then ift the power welsher unit (O). Twist toward the higher concentration Off the wall mount. of bubbles for more soap, or the opposite direction for less.
OPERATING INSTRUCTIONS Operation Tips » Note: East the GFC! before sate use: 1. Plug FOIL into power pullet. indicator should turn green to show they cons has power. 2. Crass test button, green indicator should turn off to verify that GFO! cut off power to the cons. 3. Press reset bunion green indicator should s on §0 show that cord has prows again. 4. Wuhan GUCCI Is working properly, green indicator will tum on wham power i3 applied.
Storage «When your pressure washer session has been completed, rn off the power chaotic. Unitedly e power cord from the outfield. Tum off the warts supply. Pull the rigger on the spray gun 2-3 seconds to drain out tha access Walter and to release any remaining water pressures. Do not allow the power washer to run with no wale flowing through It » Samovars high pressures hiss from spray gun and unscrew the other and of the high pressure hose from the power washer. + Remove lance from the gun.
ol S Pump Saver is a product that protects and prolongs the life of he pump. This will keep the infernal pairs of the pump lubricated and protects from freezing wheels being stored In ALL climates. it also assists with protection from internet! corrosion. You can visit you local Guardsmen store or order online st www, guardsmen Pump Saver instructions Folio the previous storage instructions for your prows washer. T prevent staining, protect the surface under the power washer from any excess fluid.