Installation Instructions

FIG. 3
A B
C D
FIG. 2
Switch
Page 7
WARNING:
Check and make sure there
is no sign of physical damage to the product when
unpacking. Do not use damaged product.
SETTING UP AND BREAKING DOWN THE
WORK LIGHT
Your work light is fully assembled and ready to use out
of box.
To Set Up the Light: From folded position A to working
position D:
1. Unwrap the power cord.
2. Release the leg locking lever. See position A.
3. Expand the tripod legs and then lock the leg locking
lever. See position B.
4. Place the light panel locking button at the Unlock
position, then flip the light panels up. See position C.
5. Release the tripod locking levers, raise the tripod to
desired height, then lock it. See position D.
6. Adjust the light panels to be desired position.
To Break Down the Light: From postion D back to
position A.
1. Release the tripod locking levers, lower tripod all the
way down and lock both levers
2. Fold the light panels down in a tube shape.
3. Release the leg locking lever.
4. Raise the leg connector until the end of light panels
nest inside.
5. Lock the leg locking lever.
6. Wrap the power cord.
ASSEMBLY INSTRUCTIONS
OPERATION
SWITCH ACTION
Your light has a white color on-board switch. This switch
turns the light On and Off and control the brightness
settings. The light modes rotates in the following
sequence by each press on the switch:
ON (6,000 Lumens) - ON (3,000 Lumens) - OFF
The switch has a delayed “OFF” function. If a light mode
stays on for more than 15 seconds, the next press on the
swich will turn off the light.