Installation Instructions

USE AND CARE
• Clean only with dry cloth or additional soap . Certain cleaning agents and solvents are harmful
to plastics and other insulated parts . Some of these include : gasoline , turpentine, lacquer
thinner, paint thinner, chlorinated cleaning solvents , ammonia and household detergents
containing ammonia .
• Keep the apparatus handle clean, dry and free of oil or grease.
• Do not expose instrument (display) to moisture
• Always remove the batteries before cleaning .
• Replace all batteries at the same time with new ones and use only the size and type
of battery specified
• Attention should be given to the environment aspects of battery disposal
• Permanent damage to the flex tube and loss of operation will occur if the flex tube is
subjected to narrow radius or sharp angle bends .
CLEANING AND STORAGE
1. AFTER USE, use a mild detergent on a clean cloth to remove any oil, grease or dirt from
the Camera , especially on the buttons and ports , being careful to not put excessive
pressure on the Display Screen .
2. Remove batteries before storage .
3. Store the Camera, cables and accessories in a locked area out of the reach of children .
TOOL SET UP
I.A WARNING:I TO PREVENT SERIOUS INJURY FROM ELECTRICAL SHOCK :
Make sure that the Camera is OFF before performing any procedure in this section.
1. Open battery compartment by sliding battery door down
2. Insert 4 AA alkaline batteries , making sure to insert correctly according to polarity
3. Connecting Cable :
a. Carefully push Cable 's key into Cable Connector 's slot.
b. Turn Cable Connector counterclockwise until the Cable and Cable Connector
are securely attached.
4. Disconnecting Cable :
a. Turn Cable Connector clockwise until the Cable and Cable Connector are disconnected.
b. Remove Cable .
Slot
Ca~
Key
Connector
Page3
NOTES
Pages