Use And Care Manual
Page 11
Remove the plug from the socket before carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional lubrication or maintenance. There are no user serviceable
parts in your power tool. Never use water or chemical cleaners to clean your power tool. Wipe
clean with a dry cloth. Always store your power tool in a dry place. Keep the motor ventilation
slots clean. Keep all working controls free of dust. Occasionally you may see sparks through
the ventilation slots. This is normal. If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualied persons in order to avoid a hazard.
If your power tool becomes too hot, especially when used at low speed, set the speed to maximum
and run with no load for 2-3 minutes to cool the motor. Avoid prolonged usage at very low speed.
Always use a sanding belt suited to the material you wish to sand. Always ensure the work-piece
is rmly held or clamped to prevent movement. Support large panels close to the sanding area.
Any movement of the material may affect the quality of the sanding nish. Start your sander before
sanding and turn off only after stopping sanding. For best results sand wood in the direction of the
grain. Do not start sanding without the sanding belt tted. Empty the dust bag every 5 minutes or
sooner to ensure efcient dust collection.
WORKING HINTS FOR YOUR BELT SANDER
MAINTENANCE