Wet/Dry Vacuum Pump Accessory 240-5269 OPERATOR’S MANUAL CAUTION: To Reduce The Risk Of Injury, User Must Read And Understand Operator's Manual. Save These Instructions For Future Reference.
TABLE OF CONTENTS SECTION PAGE Safety Instructions & Warnings.......................................................................................................2 Introduction......................................................................................................................................5 Unpacking & Checking Carton Contents.........................................................................................6 Getting to Know Your Pump............................................
SAFETY INSTRUCTIONS & WARNINGS The purpose of safety symbols is to attract our attention to possible dangers. The safety symbols, and the explanations with them, deserve your careful attention and understanding. The symbol warnings do not by themselves eliminate any danger. The instructions and warnings they give are no substitutes for proper accident prevention measures.
SAFETY INSTRUCTIONS & WARNINGS IMPORTANT SAFETY INSTRUCTIONS Safety is a combination of using common sense, staying alert, and knowing how your Pump Accessory works. • SAFETY SIGNAL WORDS • DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in serious injury or death. WARNING: Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.
SAFETY INSTRUCTIONS & WARNINGS CAUTION: • To reduce the risk of hearing damage, wear ear protectors when using for extended hours or using in a noisy area. • For dusty operations, wear dust mask. Use this Pump Accessory only as described in this manual. Observe the following warnings that appear on the motor housing of your Pump Accessory and GFCI housing. WARNING: FOR YOUR OWN SAFETY, READ AND UNDERSTAND OPERATOR’S MANUAL. DO NOT RUN UNATTENDED.
INTRODUCTION Grounding Instructions This appliance must be grounded. If it should malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. The plug must be inserted into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. WARNING: Risk of electric shockThis pump is supplied with a grounding conductor and grounding- type attachment plug.
UNPACKING & CHECKING CARTON CONTENTS Remove all contents from the box. Remove the power head and take out any contents inside the collection tank. Check each item against the carton contents list. Shut-Off Valve Strainer Adapters Drain Cap Screw Pump Accessory Operators Manual .
GETTING TO KNOW YOUR PUMP Familiarize yourself with the control and features of your Pump Accessory before operating.
ASSEMBLY Pump Accessory Assembly Your Pump Accessory will work on most Wet/ Dry Vacuums that have a drain at the bottom of the drum. When attaching the pump to the drain of your vacuum, you will use most of the parts included in this kit. 1. Mount adapter onto the drain of your Wet/ Dry Vac and firmly tighten by hand. Locate screw notch and install the supplied #16 x 2.6-inch long screw. (fig. 3) Fig.
OPERATION WARNING: To reduce the risk of fire or explosion, do not operate this vac in areas with flammable gases, vapors, or explosive dust in the air. Flammable gases or vapors include but are not limited to: lighter fluid, solvent type cleaners, oil-based paints, gasoline, alcohol, or aerosol sprays. Explosive dusts include but are not limited to: coal, magnesium, aluminum, grain, or gun powder. Do not vacuum explosive dust, flammable or combustible liquids, or hot ashes.
USING YOUR PUMP ACCESSORY Turn on the unit by pushing the switch from position “O” to position “l”. The symbols used on the switch actuator are international “On & Off” symbols. “O” is the symbol for “OFF” and “l” is the symbol for “ON”. (fig. 7) Fig. 7 ON/OFF Switch 3. Turn your vac off, allowing it to stop completely. Position hose to the desired location to empty drum contents. Open the shut-off valve located between the outlet of the Pump Accessory and the garden hose. (fig. 9) Fig.
MAINTENANCE Cleaning Strainer Cord Storage WARNING: To reduce the risk of injury from accidental starting, unplug power cord before cleaning strainer. Wrap the cord and use the attached hook & loop strap to retain the cord. Your pump requires no additional lubrication or maintenance beyond keeping it clean and free of debris. When not in use, store your Pump Accessory in a cool, dry location with the cord wrapped using the supplied hook & loop cord wrap.
REPAIR PARTS 240-4836 Wet/Dry Vac Pump Accessory Always order by part number, not by key number. Always mention the model number when ordering parts. The model number is found on the serial plate located on the pump. WARNING: To reduce the risk of injury from electrical shock, unplug power cord before servicing the Wet/Dry Vac Pump Accessory. 1 5 Key 1 2 3 4 5 6 7 Description Adapter 1(small) Adapter 2(large) Strainer Shut-Off Valve Screw Drain Cap Operator's Manual 2 6 3 4 7 Part # PA01DM.10.
NOTES Page 13
Wet/Dry Vacuum Pump Accessory WARRANTY 90-DAY MONEY BACK GUARANTEE This MASTERFORCETM brand pump accessory carries our 90-Day Money Back Guarantee. If you are not completely satisfied with your MASTERFORCETM brand pump accessory for any reason within ninety (90) days from the date of purchase, return the pump accessory with your original receipt to any MENARDS® retail store, and we will provide you a refund - no questions asked.
© 2011 Menard, Inc.
