Use And Care Manual

Page 9
WARNING:
To reduce the risk of
fire or explosion, do not operate this vac
in areas with flammable gases, vapors, or
explosive dust in the air. Flammable gases
or vapors include but are not limited to:
lighter uid, solvent type cleaners, oil-based
paints, gasoline, alcohol, or aerosol sprays.
Explosive dusts include but are not limited
to: coal, magnesium, aluminum, grain, or
gun powder. Do not vacuum explosive dust,
flammable or combustible liquids, or hot
ashes. Do not use this vac as a sprayer.
To reduce the risk of health hazards from
vapors or dusts, do not vacuum toxic
materials. Store Pump Accessory indoors.
Do not submerse pump or power cord.
WARNING:
The operation of any
utility vac can result in foreign objects being
blown into the eyes, which can result in
severe eye damage. Always wear safety
eyewear complying with ANSI Z87.1 (or in
Canada, CSA Z94.3) before starting operation.
Safety eyewear is available at many local retail
stores.
CAUTION:
To reduce risk of hearing
damage, wear ear protection when using
the pump accessory for extended hours or
when using it in a noisy area.
To reduce the risk of electric shock, this
Pump Accessory has a built-in GFCI (Ground
Fault Circuit Interrupter) plug with a ground
connection. The plug must be used on a
properly grounded outlet. If the plug does not t
into the outlet, contact a qualied electrician to
install the proper outlet. Do not modify the plug
in any way.
After you plug the power cord into the outlet,
you should always test the GFCI. Press the
red “RESET” button to reset your Pump
Accessory. This has to be done each time the
pump accessory is plugged into an outlet. If the
red “RESET” indicator does NOT pop up, your
unit is not functioning properly and you should
contact an Independent Service Center to have
your Pump Accessory serviced. Once you have
plugged the power cord into the outlet and the
tested GFCI, you are ready to run your pump.
(g. 6)
Fig. 6
TEST
Button
RESET
Button
GFCI (Ground Fault
Circuit Interrupter)
RESET
TEST
NOTE: The Pump Accessory should not be
operated on the same circuit as the Wet/Dry
Vac.
OPERATION