Use And Care Manual

ManualsBrandsMasterforce ManualsToolsWet/Dry Vacuum Water Pump Accessory

7

8

9

Page 10

Turn on the unit by pushing the switch from

position “O” to position “l”. The symbols used

on the switch actuator are international “On &

Off” symbols. “O” is the symbol for “OFF” and “l”

is the symbol for “ON”. (g. 7)

Fig. 7

ON/OFF

Switch

O = OFF I = ON

Your Pump Accessory will work best when being

used to pump large amounts of liquid. If the liquid

does not ll the drum so that it covers the drain on

the inside of your Wet/Dry Vac, the pump may not

function properly. Due to the function of Wet/Dry

Vacs and the Pump Accessory, the pump will not

operate properly if your vac is running.

1. Make sure that your pump is connected to

the drain of your vac (See Assembly), and

that the GFCI is functioning properly. If you

require a hose, connect it to the outlet of

the pump.

2. Close the shut-off valve and vacuum up the

intended liquid until your Wet/Dry Vac stops

picking up the liquid or until all liquid is

cleaned up. (g. 8)

Fig. 8

Closed

Position

3. Turn your vac off, allowing it to stop

completely. Position hose to the desired

location to empty drum contents. Open the

shut-off valve located between the outlet of

the Pump Accessory and the garden hose.

(g. 9)

Fig. 9

Open

Position

4. Turn your pump on allowing it to pump

out as much of the liquid in the drum as

possible. When you notice that the pump

is no longer moving any water through the

hose and the speed of the motor increases,

turn the pump off.

5. To verify drum is mostly empty, unplug the

pump and vac, remove vacuum powerhead

and inspect the drum contents. If liquid is

still in drum, see “Troubleshooting” section

on page 12.

NOTE: Do not run pump dry or damage may

occur to internal components of the pump and

void warranty.

6. Unplug the pump, unplug and remove the

powerhead of your Wet/Dry Vac and clear

any debris that may have collected on or

near the strainer of the pump. Reinstall the

power head and repeat steps 2 through 5

as required.

WARNING:

To reduce the risk of re

or electric shock, do not run vac unattended.

USING YOUR PUMP ACCESSORY