Use And Care Manual

Page 8
ASSEMBLY
Pump Accessory Assembly
Your Pump Accessory will work on most Wet/
Dry Vacuums that have a drain at the bottom
of the drum. When attaching the pump to the
drain of your vacuum, you will use most of the
parts included in this kit.
1. Mount adapter onto the drain of your Wet/
Dry Vac and rmly tighten by hand. Locate
screw notch and install the supplied #16 x
2.6-inch long screw. (g. 3)
Fig. 3
Small
Adapter
Diameter of Drain on
Wet/Dry Vac is 1-1/2
Inch: Use Small Adapter
Diameter of Drain on
Wet/Dry Vac is 2 Inch:
Use Large Adapter
Large
Adapter
Screw Notch
Screw
Small Adapter
NOTE: The drain adapter can now be a
permanent fixture on your vacuum. Use the
included drain cap when the pump is not in use.
2. Push the strainer into the large inlet of
the pump assembly. With the strainer
installed, slide the Pump Accessory into the
adapter previously installed on the vacuum,
positioning the pump in an upright fashion.
Tighten the coupler by hand until secure.
(g. 4)
Fig. 4
Strainer
Large
Inlet
Pump Accessory
Coupler
NOTE: The connection is designed to prohibit
rotation of the pump after installation, so proper
alignment must be achieved before the coupler
has been tightened.
3. After the pump assembly is securely
attached to the drain, the shut-off valve
should be installed to the outlet of the
pump and turned to the closed position.
Without this shut-off valve installed, liquid
will leak through the pump outlet. Connect
a standard size garden hose (not included),
up to 50 feet in length, to the outlet end of
the shut-off valve. Longer lengths will cause
reduced performance of the pump. (g. 5)
Fig. 5
Pump Accessory
in Upright
Position
Coupler
Shut-off Valve
Garden Hose
(Not Included)