Use And Care Manual

Page 13
5. ADJUSTABLE OUTER FLANGE CLAMP-
ING
The outer ange (5) should be adjusted to suit
different disc thickness. For thinner cutting
or diamond discs the raised part of the outer
ange is tted facing away from the disc (See
Fig. G-2).
For thicker grinding discs the raised part of
the outer ange is tted facing towards the
disc to provide improved support for the disc
hole (See Fig. G-1). Always ensure your disc is
securely clamped.
Fig. G-1
Fig. G-2
6. STARTING OPERATION
To start the power tool, push the on/off switch
(1) forward.
To lock the on/off switch (1), press the on/off
switch (1) down at the front until it engages.
To switch off the power tool, release the on/
off switch (1) or, if it is locked, briey push
down the back of the on/off switch (1) and then
release it. (See Fig. H)
NOTE:
When the on/off switch (1) is locked, the
machine is on working.
1. When the power is out. The machine
stopped, the on/off switch (1) is still locked.
2. After restoration of power, the machine
cannot work directly. then on/off switch (1)
is still locked, briefly push down the back of
the on/off switch (1) and then release it.
3. To press the on/off switch (1) down at the
front until it engages.
Fig. H
1
7. WORKING INSTRUCTIONS
• Clamp the workpiece if it does not remain
stationary due to its own weight.
• Do not strain the machine so heavily that it
comes to a standstill.
• Grinding and cutting discs become very hot
while working; do not touch until they have
cooled.
• Pull the plug from the socket-outlet when
not using the machine. With the plug in-
serted and mains voltage existing, the power
tool still has low power consumption even
when it switched off.
OPERATION