Use And Care Manual

Page 11
OPERATION INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
This tool may cause hand-arm vibration
syndrome if its use is not adequately
managed.
1. INSTALLING THE AUXILIARY HANDLE
(SEE A)
You have the option of two working positions to
provide the safest and most comfortable control
of your angle grinder. The handle is screwed
clockwise into either hole on the sides of the
gear case.
Fig. A
2. HAND GRIP AREAS
Always hold your angle grinder rmly with both
hands when operating.
3. ADJUSTING WHEEL GUARD (SEE B1, B2,
B3)
For work with grinding or cutting discs, the
wheel guard must be mounted.
Wheel Guard for Grinding
The coded projection on the wheel guard (5)
ensures that only a guard that ts the machine
type can be mounted.
Open the clamping lever (12). Place the wheel
guard (5) with coded projection into the coded
groove on the spindle of the machine head and
rotate to the required position (working position).
To fasten the wheel guard (5), close the
clamping lever.
The closed side of the wheel guard (5) must
always point to the operator.
NOTE: With the clamping lever (12) open the
clamp adjusting nut (10) can be adjusted to
ensure the guard is securely clamped after the
clamping lever (12) is nally closed.
WHEEL GUARD FOR CUTTING
WARNING
For cutting metal, always work
with the wheel guard for cutting (14).
The wheel guard for cutting (14) is mounted
in the same manner as the wheel guard for
grinding (5).
Fig. B1
Open Guard Clamping Lever
Insert and Turn
Counterclockwise
Projection
Fig. B2
Working Position (Example)
Opened Guard Clamping Lever
OPERATION