Use And Care Manual

Page 12
Fig. B3
Working Position (Example)
Closed Guard Clamping Lever
4. SPINDLE LOCK BUTTON
Must only be used when changing a disc. Never
press when the disc is rotating!
5. FITTING THE DISCS (SEE C1, C2, C3)
Put the inner ange onto the tool spindle. Ensure
it is located on the two ats of spindle (See C1).
Place the disc on the tool spindle and inner
fIange. Ensure it is correctly located. Fit the
threaded outer ange making sure it is facing in
the correct direction for the type of disc tted.
For grinding discs, the ange is tted with the
raised portion facing towards the disc. For
cutting discs, the ange is tted with the raised
portion facing away from the disc (See C2).
Press in the spindle lock button and rotate the
spindle by hand until it is locked. Keeping the
lock button pressed in (C3), tighten the SDS
outer ange with hand (See C4).
Fig. C1
Fig. C2
Fig. C3
Fig. C4
OPERATION