Use And Care Manual

Page 14
Fig. F
10. TO REPLACE THE BRUSHES (SEE G)
Before any work on the machine itself, pull
the mains plug.
Remove the screw securing the motor brush
cover. Remove the cover, gently lift out, and
pull the spade connector free. Hold back the
coil spring and slide the worn brush out of the
housing, carefully release the spring. Locate the
replacement brush, (in the same orientation)
whilst again holding back the coil spring. Ensure
the brush is located and free to move, release
the spring; it should now sit within the groove on
the brush. Re-attach the spade connector to the
terminal, replace the cover and secure.
Fig. G