Use And Care Manual

Page 10
DRY VACUUMING
WARNING:
BE SURE TO READ,
UNDERSTAND, AND APPLY INFORMATION,
ENTITLED ‘SAFETY INSTRUCTIONS &
WARNINGS’. DO NOT VACUUM IN AREAS
WITH FLAMMABLE GASES, VAPORS,
OR EXPLOSIVE DUSTS IN THE AIR.
FLAMMABLE GASES OR VAPORS INCLUDE
BUT ARE NOT LIMITED TO: LIGHTER
FLUID, SOLVENT TYPE CLEANERS, OIL-
BASED PAINTS, GASOLINE, ALCOHOL OR
AEROSOL SPRAYS. EXPLOSIVE DUSTS
INCLUDE BUT ARE NOT LIMITED TO: COAL,
MAGNESIUM, GRAIN OR GUN POWDER. TO
REDUCE THE RISK OF HEALTH HAZARDS
FROM VAPORS OR DUST, DO NOT
VACUUM TOXIC MATERIALS.
1. Verify that the power cord is disconnected
from the outlet. (fig. 1)
Fig. 1
2. In order to prepare your vacuum for dry
vacuuming, verify that the cartridge filter is
securely mounted. Make sure the filter is
pushed in until it stops against the power
head. (fig. 2) Your Wet/Dry Vac comes
with the cartridge filter pre-installed. For
installation instructions, see page 16.
Fig. 2
3. Place filter retainer on top of cartridge filter
and tighten by turning the retainer handle
clockwise. (fig. 3)
Fig. 3
4. For improved dust filtration when dry
vacuuming, install a dust collection bag.
To install the collection bag, firmly slide
cardboard collar opening onto the vacuum
port def lector, then position the bag so that
it is distributed around the inside of the tank.
(Dust collection bag sold separately.) (fig. 4)
Fig. 4
DRY VACUUM OPERATION