Use And Care Manual

Page 14
BLOWER OPERATION
This Wet/Dry Vac has blowing capabilities only
when the hose is inserted into the blower port.
To use the blower feature follow the instructions
listed.
WARNING:
ALWAYS WEAR SAFETY
GOGGLES COMPLYING WITH ANSI Z87.1
(or in Canada, CSAZ94.3) BEFORE USING
BLOWER.
CAUTION:
KEEP BYSTANDERS
CLEAR FROM BLOWING DEBRIS.
WARNING:
WEAR A DUST MASK IF
BLOWING CREATES DUST THAT MIGHT BE
INHALED.
1. Verify that the power cord is disconnected
from the outlet. (fig. 1)
Fig. 1
2. Make sure the collection tank is empty and
the dust collection bag is removed before
using as a blower.
3. Remove hose from the vacuum port.
4. Remove air/noise diffuser from blower port.
(fig. 2)
Fig. 2
5. Insert the larger end of the hose into the
blower port on the back side of the power
head. (fig. 3)
Fig. 3
6. Fit the desired attachment to the hose. (fig. 4)
Fig. 4
7. Ensure the power switch is turned off and
plug into the power supply. (fig. 5)
8. Before turning on the vac, firmly hold loose
end of the hose. Turn the motor on by
pressing the switch to the ‘I’ ON position.
(fig. 6)
Fig. 5 Fig. 6