Use And Care Manual

Page 7
GENERAL ASSEMBLY INSTRUCTIONS
WARNING:
DO NOT PLUG POWER
CORD INTO POWER OUTLET. MAKE
SURE PLUG IS DISCONNECTED BEFORE
ASSEMBLING THE WET/DRY VAC.
UNPACKING YOUR WET/DRY VACUUM &
GENERAL ASSEMBLY
1. Verify that the power cord is disconnected
from the outlet. (fig. 1)
Fig. 1
2. Insert the handle into the slots located on
the top of power head and secure it with the
screws provided. Do not over-tighten the
screws. (fig. 2)
Fig. 2
3. Undo the latches. (fig. 3)
Fig. 3
4. Lift the power head off the collection tank.
(Fig. 4)
Fig. 4
5. Remove the contents from inside the
collection tank. Make sure you have all
contents as listed on page 5. (Fig. 5)
Fig. 5
6. Turn the collection tank upside down and
insert the two (2) casters into the slots on
the front side of the collection tank. Apply
downward pressure until the casters snap
into place. (Fig. 6)
Fig. 6