Use And Care Manual

Page 10
DRY VACUUMING
WARNING:
BE SURE TO READ,
UNDERSTAND, AND APPLY INFORMATION,
ENTITLED ‘SAFETY INSTRUCTIONS &
WARNINGS’. DO NOT VACUUM IN AREAS
WITH FLAMMABLE GASES, VAPORS,
OR EXPLOSIVE DUSTS IN THE AIR.
FLAMMABLE GASES OR VAPORS INCLUDE
BUT ARE NOT LIMITED TO: LIGHTER
FLUID, SOLVENT TYPE CLEANERS, OIL-
BASED PAINTS, GASOLINE, ALCOHOL OR
AEROSOL SPRAYS. EXPLOSIVE DUSTS
INCLUDE BUT ARE NOT LIMITED TO: COAL,
MAGNESIUM, GRAIN OR GUN POWDER. TO
REDUCE THE RISK OF HEALTH HAZARDS
FROM VAPORS OR DUST, DO NOT
VACUUM TOXIC MATERIALS.
1. Verify that the power cord is disconnected
from the outlet.(fig.1)
Fig. 1
2. In order to prepare your vacuum for dry
vacuuming, verify that the cartridge filter
is securely mounted. With power head
removed and in an upside down position,
make sure the filter is pushed in until it
stops against the power head and the
retainer is installed. (fig. 2 & 3) Your Wet/
Dry Vac comes with the cartridge filter pre-
installed. For installation instructions, see
page 17.
Fig. 2 Fig. 3
3. Optional: For improved dust filtration, fit
dust collection bag flange onto the inlet
port, taking care not to damage the bag.
(Dust bag sold separately.) (fig.4)
Fig. 4
4. Place the power head back on the collection
tank, and secure it in place using the latches.
(fig.5)
Fig. 5
DRY VACUUM OPERATION