Use And Care Manual

Page 8
7. Insert the wheel axle into the rear wheel
housing. Insert a washer onto the axle
followed by rear wheel and insert another
washer. Insert the ‘R’ locking pin into the
hole on the end of the axle to lock the
wheel. Snap the hub cap onto the wheel.
Repeat the same steps at the other end of
the axle. (fig. 7)
Fig. 7
8. Insert the push/pull handle into the handle
socket mounted on the tank body. Push
down until the locking pins click into place.
(fig. 8)
Fig. 8
9. Remove the screw from the cord wrap hook
by turning it counter-clockwise. Insert the
screw into the push/pull handle. Insert the
cord wrap hook onto the screw and turn
clockwise to tighten. (fig. 9)
Fig. 9
10. Your vacuum comes ready for dry vacuum
cleaning. If cartridge filter is not installed
refer to page 17 for filter installation.
(fig. 10 & 11)
Fig. 10 Fig. 11
11. Optional: For improved dust filtration during
dry vacuum operation, fit dust collection bag
f lange onto the inlet port, taking care not to
damage the bag. (Dust bag sold separately.)
(fig. 12)
Fig. 12
GENERAL ASSEMBLY INSTRUCTIONS