Use And Care Manual

Page 18
Change the collection bag
When the collection bag is 3/4 full, it MUST
be replaced. Excessive over filling of this bag
makes it difficult to remove from the vacuum
tank and can result in breakage and spills. The
collection bag comes equipped with a quick
closing f lap. When collection bag becomes 3/4
full, turn off vacuum and slowly remove the
collection bag from the tank until the opening in
the collection bag is clear of the tank. Pull the
closure slide up on the collection bag, which
will close the opening. Hazardous materials
must be disposed of properly. NEVER throw
contaminated debris in your usual trash
receptacle. Place closed collection bag in
an OSHA approved poly bag or container
marked with HAZARDOUS MATERIAL warning
and dispose in accordance with your local
Hazardous Waste Regulations.
Change the pre-lter
The pre-filter should be replaced with every
fifth change of the collection bag and whenever
there is damage or a visible collection of debris
on the outside of the filter.
Change the HEPA lter
Replace the HEPA filter when loss of vacuum
power continues to occur after you have
checked for an obstructions in the hose or
wand. Also install a new collection bag and pre-
filter.
WHEN TO CHANGE FILTERS