Use And Care Manual

Page 8
4. Remove the contents from inside the
collection tank. Make sure you have all
contents as listed on page 5. (fig. 4)
Fig. 4
5. Turn the collection tank upside down and
insert the two caster feet into the front slots
on the base. Apply downward pressure to
each caster. Casters will "snap" into place
when installed properly. Verify that the
casters are mounted correctly. (fig. 5)
Fig. 5
6. Insert the wheel axle into the base. Insert
washer onto the axle followed by rear wheel
and insert another washer. Insert the ‘R’
locking pin into the hole on the end of the
axle to lock the wheel. Snap the hub cap
onto the wheel. Repeat the same steps at
the other end of the axle. (fig. 6)
Fig. 6
7. Your vacuum comes ready for dry vacuum
cleaning. If HEPA filter and pre-filter are
not installed refer to page 15 for installation
instructions. (fig. 7-10)
Fig. 7 Fig. 8
Fig. 9 Fig. 10
GENERAL ASSEMBLY INSTRUCTIONS