Use And Care Manual

Page 14
LIQUID VACUUM OPERATION
LIQUID VACUUMING
WARNING:
BE SURE TO READ,
UNDERSTAND, AND APPLY INFORMATION,
ENTITLED ‘SAFETY INSTRUCTIONS &
WARNINGS’. DO NOT VACUUM IN AREAS
WITH FLAMMABLE GASES, VAPORS,
OR EXPLOSIVE DUSTS IN THE AIR.
FLAMMABLE GASES OR VAPORS INCLUDE
BUT ARE NOT LIMITED TO: LIGHTER
FLUID, SOLVENT TYPE CLEANERS, OIL-
BASED PAINTS, GASOLINE, ALCOHOL, OR
AEROSOL SPRAYS. EXPLOSIVE DUSTS
INCLUDE BUT ARE NOT LIMITED TO: COAL,
MAGNESIUM, GRAIN, OR GUN POWDER.
TO REDUCE THE RISK OF HEALTH
HAZARDS FROM VAPORS OR DUST, DO
NOT VACUUM TOXIC MATERIALS.
WARNING:
DO NOT PLUG POWER
CORD INTO POWER OUTLET. MAKE
SURE PLUG IS DISCONNECTED BEFORE
CHANGING OR CLEANING FILTERS.
IMPORTANT!
When vacuuming large volumes
of liquids, we recommend that you remove the
vacuum from the mounting rack and put it on
the f loor. The vacuum can be heavy when full of
liquids and may be difficult to remove from the
rack.
DO NOT USE THE CARTRIDGE FILTER FOR
LIQUID VACUUMING.
1. Verify that the power cord is disconnected
from the outlet (fig. 1). Verify that the
collection tank is clean and free of dust and
dirt.
Fig. 1
2. Remove the cartridge filter, then carefully
install the foam wet filter over the filter cage
(fig. 2) and place the power head back on
the collection tank. See filter installation
instructions on page 19.
Fig. 2
3. Fit the desired nozzle to the vacuum hose.
(fig. 3)
Fig. 3
4. Verify that the switch is in the ‘O’ OFF
position before plugging the power cord into
the outlet. (fig. 4 & fig. 5)
Fig. 4