Use And Care Manual

ManualsBrandsMasterforce ManualsTools5 Gallon 5 Peak HP Wall Mountable Wet/Dry Shop Vacuum with Remote Control

Page 18

INSTALLING & CLEANING THE CARTRIDGE FILTER

Installing Cartridge Filter

1. Verify that the power cord is disconnected

from the outlet. (fig. 1)

Fig. 1

2. Remove power head and place in upside

down position.

3. Install the cartridge filter over the filter cage

with the flat end of the filter towards the

vacuum power head. Carefully push filter in

until it stops against the power head. (fig. 2

& 3)

Fig. 2 Fig. 3

4. Place filter retainer on top of cartridge filter

over the raised lip and tighten down by

turning retainer clockwise, taking care not

to over-tighten. (fig. 4 & 5)

Fig. 4 Fig. 5

Removing and Cleaning Cartridge Filter

1. Unlock and remove the filter retainer by

turning retainer handle counterclockwise.

2. Carefully remove the cartridge filter by

sliding it off the filter cage. (fig. 6)

Fig. 6

3. Clean the cartridge filter by gently tapping

or brushing dirt off. Cleaning should not be

done indoors in living areas. For optimal

performance a new filter is recommended.

4. Install cleaned or new filter as instructed

above in steps 2 and 3 of Installing

Cartridge Filter.

5. Wet filters should be removed and allowed

to dry for 24 hours before installing onto the

filter cage.