Instruction manual

MATADOR INSTRUCTION MANUAL
29
Appliance conversion - Main Burners
1. Remove cooking grate, hot plate, and heat tents.
2. Remove clips retaining flame carryover tubes and burners.
3. Remove flame carryover tubes and burners.
4. Using a 7 mm nut drive remove LP orifices and save in case barbecue needs to be converted
back to LP.
5. Remove control knobs, LP bezel plates and screws and washers (Shown below). Only do one
control knob at a time.
6. Install NG bezel plates supplied in hardware pack using screws and washer removed In step 5
and replace control knobs (shown below).
7. Replace burners, flame carryover tubes, retaining clips, heat tents, cooking grate and hot plate.
Appliance conversion - Side Burner
1. Remove side burner.
2. Using a 7 mm nut drive remove LP orifices and save in case barbecue needs to be converted
back to LP.
3. Remove control knobs, LP bezel plates and screws and washers (Shown below).
4. Install NG bezel plates supplied in hardware pack using screws and washer removed in step 3
and replace control knobs (shown below).
5. Replace side burner.
Remove LP Bezel
Install NG Bezel
NG Bezel
TEST OPERATION OF APPLIANCE BEFORE LEAVING
OFF
N
a
t
u
r
a
l
G
a
s
TOP