User's Guide

12 Chapter 2. Quick Installation Guide
resistance of the Gateway. Keep in mind that PoE power injector is not waterproof and has to be
additionally protected if it is to be placed outside.
2.5.1 Wall Mounting
The screws and screw anchors are included in the package, users can drill two 6mm hole on the wall
and apply screw anchors to them.
• Determine the place of mount, it should be an even surface.
• Mark two holes that are going to be drilled, the distance between them. should be 54mm, and
they should be horizontally aligned .
• Drill two 6mm hole, apply screw anchors and screws.
• Adjust the screw spacing.
• Push the screws heads through the larger opening hole of the Gateways fixture and then pull
the Gateway down so the screws get locked in position.
Figure 2.2: Mounting the MX1901/2 Gateway to the wall.
2.5.2 Pole mounting
The Gateway can be easily connected to a pole using a stainless steel clamp included in the box. The
Gateways fixture is specially designed to fit to poles curvature. To make the mounting even more
stable it is a good idea to use two clamps spaced as far apart as possible.
• Determine the place of mount, we recommend a round pole
• Position the Gateway on desired place, and fasten the stainless steel clamp.
• Tighten the screw of the clamp enough to make the mounting stable but not to much to brake
the plastic fixture of the Gateway.