Operation Instruction

Step 10: The system starts playing the recorded data. All
items are displayed in text form by default.
Step 11: To review the dynamic data, select the
corresponding data stream items and tap on “OK”.
Step 12: Dynamic data also can be viewed in
single/merged graphic form.
Data Review & Sync
Step 1: Insert the external storage device into the Data I/O of the tablet. Go to “Toolbox”,
tap on “Settings” -> “Backup/Restore.” Tap on “Backup.”
Step 2: Choose the “MaxdriveData” folder and tap on “Backup” to copy it onto the
storage device.
Backup Maxdrive Data
Warning
Andy Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy, and if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
MAXDRIVE(FCC ID: 2AUKMMAXDRIVE) complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with a minimum distance of
20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter.
Hereby, Matco Tools declares that MAXDRIVE(model MAXDRIVE) is in compliance with the essential
requirements and other relevant provisions of Radio Equipment Directive 2014/53/EU.
Operation frequency: Bluetooth 2402-2480MHz,
Max. RF output power: 0.77dBm,
The RF frequencies can be used in Europe without restriction.