Users Manual Part 2

MDMAXLITEA

During fixing, please do not cut power or switch to other

interfaces.

Note: please be sure to keep the VCI device powered on

while performing the operation.

6.4.3 Icon Size

This feature allows you to set the size of the diagnostic

software icon according to your preference.

Drag the slider to different size and the system will display

the corresponding effect.

6.4.4 MD Printer Connection

This option is used to establish a wireless connection

between the tablet and the printer (sold separately) while

performing printing operations.

The App is compatible with the “Matco Tools Wi-Fi Printer”

(sold separately) and “System” (external printer).

Follow the steps below to connect the Wi-Fi printer.

1. Tap on “MD Printer Connection”.

Below describes how to conﬁgure the Wi-Fi Printer.

Fig. 6-5

A. If it is the ﬁrst time you have operated this printer, please

proceed the following:

2. For initial use, you are suggested to reset the printer:

Press and hold [MODE] & [FEED] for 8 seconds, the

following resetting command will be printed out:

at + default = 1

at + reboot = 1

rebooting...

3. Tap on “Reset” to conﬁgure Wi-Fi printer.

Step 1: Connect the printer:

Tap on “Scan” to select the desired printer hotspot named

with X-431PRINTER-XXXX (XXXX stands for 4 characters),

and then tap on “Connect” to enter Step 2.

Step 2: Join the printer into LAN:

Tap on “Scan” to select the desired local Wi-Fi network