User's Guide

User Guide
3-1
Load cards in Hopper Close back Front door
Front Slot (Manual Card Hopper)
The manual card feeder is always ready for use and is prioritized. It is suggested that it can be used when
the job requires a different card other than the ones loaded inside the input Hopper.
1) Insert the card inside the slot as per above illustration.
Adjusting the Card Thickness
The card thickness can be adjusted using the wheel inside the input Hopper.
Cards with thicknesses ranging between 0.25 mm and 1.25 mm (10 - 50 mil) can be processed by the
printer. Proceed as follows to adjust the card thickness:
1) Open the printing module compartment cover as per below instructions.