Users Manual Part 1

Full Color Card Printer
40
6 Change the settings by using the S/T
Keys, then press the SET key.
• Confirm the confirmation pattern on the card issued by
procedure 3 and adjust so that the cyan line is aligne
d
w
ith the yellow line.
• If you increase the setting value, the yellow line will
mo
ve towards the right of the cyan line.
(Setting values are by increments/decrement
s of
approximately 0.05 mm)
• Magenta is adjusted in the same way. (Cy
an is the
ba
se color so does not need to be adjusted)
• In the case of double-sided printing, adjust the rear
surf
ace in the same way. Because color ble
ed is
af
fected by printing design the adjustment value differs
for the front and rear surface.
Note
z Use a test print card since a used card cannot be reused.
z [Color Shift Hrz] in the [Image Setup] hierarchy tree is a function to automatically
correct color bleed (horizontal) of color images.
When it is set to [ON (AUTO)], correction is performed according to the design to
reduce color bleed.
Please use [ON (AUTO)] unless instructed otherwise by your reseller.
The factory default setting is [ON (AUTO)].
Y Shift Hrz-F
0
Y Shift Hrz-F
Y Shift Hrz-F
30
-30
YellowCyan
Magenta
Adjust so that the the line can be seen clearly.
(In the picture yellow is moved to the left)
Moves the card front surface yellow printing.
Moves the card front surface magenta printing.
Moves the card front surface cyan printing.
Moves the card rear surface yellow printing.
Moves the card rear surface magenta printing.
Moves the card rear surface cyan printing.
Y Shift Hrz-F
M Shift Hrz-F
C Shift Hrz-F
Y Shift Hrz-B
M Shift Hrz-B
C Shift Hrz-B
AdjustmentMenu
Operating Manual MC660
Matica Technologies