Users Manual Part 1

Full Color Card Printer

5 As time approaches for replacement of

the

Ink Ribbon or Transfer Film, a

remaining quantity notification for

these is displayed.

• In Normal Mode, if the Ink Ribbon and Transfer Film

remaining quantity

drops below the settings value (%),

then the remaining quantity notification will appear at a

set frequency (approximately 4 seconds).

→See "Changing the Ink Ribbon and Transfer Film" on

page 16 for details about changing the Ink Rib

bon or

Transfer Film.

Note

 The factory default setting for [Ribbon Notice(%)] and [Film Notice(%)] is [0].

Setting the Types of Card to Use

 Adjusting the Feed Gate Depending on Card Thickness

Adjust the card case and the gate gap to match the fed cards.

1 Open the top cover, and remove the

Card Case.

• Hold the Card Case handle, and remove.

2 Open the Card Case, and remove the

car

ds from the cassette.

• Pull the lock, and open the Card Case cover.

•

Pull the card retainer, and after removing the cards

retur

n the card retainer to its original position

• Remove the cards, and close the Card Case cover.

Card Retainer

Operating Manual MC660

Matica Technologies