Users Manual Part 1

45
3 Rotate the dial on the lower surface of
the Card Case and adjust the gate gap.
• The figures on the knob indicate the size of the gate
gap.
• If cards do not pass through the gate, turn the knob to
the right.
• If multiple cards pass through the gate, turn the knob
to the left.
Note
 The factory default setting for the gate gap is [0.76 mm].
4 Close the Top Cover.
• Face the Card Case outwards, and after returning it to its original location, close the Top Cover.
 Optimizing Transfer Conditions
Carry out secondary transfer under optimal conditions for the cards used.
Note
 You can also change the settings by using the printer driver (→See "Opening the
Printer Driver Settings Screen" on page 89).
1 Switch from Normal Mode to User
Mode.
→See "Switching to User Mode" on page 24 for details on
how to switch to User Mode.
2 Press the  Key until [Card Setup] is
displayed, then press the SET Key.
3 Confirm that [Card Type] appears, and
press the SET Key.
Align
Knob with
Marks
Ready to Print Ready to Print
Printer Info.
SET:>>
Printer Info.
SET:>>
MENU
Normal Mode User Mode
Printer Info.
SET:>>
Printer Info.
SET:>>
Card Setup
SET:>>
Card Setup
SET:>>
Card Type Card Type
SET
Card Type
PVC (0.76mm)
Card Type
PVC (0.76mm)
SET
Card Type
PVC (0.76mm)
Card Type
PVC (0.76mm)
Operating Manual MC660
Matica Technologies