Users Manual Part 1

Full Color Card Printer
46
4 Change the settings by using the S/T
Keys, then press the SET Key.
• Settings values that can be changed are as below.
•
If CARD1-3 are selected, then go to Ste
p 5. If other
settings v
alues are selected, then you hav
e finished.
Note
z The factory default setting is [PVC (0.76 mm)].
5 (Only if [CARD 1-3] are selected)
Use the S / T Keys and the SET Key to set
the transfer speed/transfer temperature.
• Use the S/T Keys to change the value, and press the
SET Key to fix the changes.
•
If the MENU Key is pressed prior to pressing the SET Key
to
fix the changes, then the changes will be canceled.
•
The left value shows the transfer speed, and the right
the transfer temperature
.
Note
z Settings can be configured using [Heater Setup] [CARD 1 (-3) Heat Speed]/[CARD 1
(-3) Heat Temp.] when setting the [CARD 1-3] transfer speed/transfer temperature
from the printer driver.
(→See "Opening the Printer Driver Settings Screen" on page 89).
Card Type
PVC (0.76mm)
Card Type
PVC (0.76mm)
Card Type
CARD3 (00/+00)
Card Type
CARD3 (00/+00)
Settings Value Details
PVC (0.76 mm) Carry out secondary transfer using conditions corresponding to 0.76 mm
thickness standard PVC card.
PET (0.76 mm) Carry out secondary transfer using conditions corresponding to 0.76 mm
thickness standard PET card.
PET-G (0.76 mm) Carry out secondary transfer using conditions corresponding to 0.76 mm
thickness standard PET-G card.
Composite PVC Carry out secondary transfer using conditions corresponding to 0.76 mm
thickness standard Composite PVC card.
PC (0.76 mm) Carry out secondary transfer using conditions corresponding to 0.76 mm
thickness standard PC card.
CARD1 (XX,+XX)
CARD2 (XX,+XX)
CARD3 (XX,+XX)
Carry out secondary transfer using conditions set for values set for
CARD 1-3. The left value is the transfer speed, and the right is the transfer
temperature. Selecting either of these settings will then transition to transfer
speed/transfer temperature settings.
→See Step 5
SET
Card Type
CARD1 (20,+00)
Card Type
CARD1 (20,+00)
Card Type
CARD1 (15,+00)
Card Type
CARD1 (15,+00)
Card Type
CARD1 (15,+00)
Card Type
CARD1 ( +00)
Settings Menu Details
Transfer speed
(left value)
Higher values mean a greater transfer speed, and lower values mean a
lower transfer speed.
Transfer temperature
(right value)
Higher values mean a greater temperature, and lower values mean a
lower temperature.
Settings Menu Details
CARD1(-3) Heat
Speed
Higher values mean a greater transfer speed, and lower values mean a
lower transfer speed.
CARD1(-3) Heat
Te m p.
Higher values mean a greater temperature, and lower values mean a
lower temperature.
Operating Manual MC660
Matica Technologies