User`s guide

4-2
This chapter describes how to place Dials & Gauges Blockset blocks in their
own window. By separating the controls from the computational blocks in the
simulation, you can make your system look neater and more user-friendly. The
sections are as follows:
•“Placing ActiveX Controls in a Different Model” on page 4-3 describes how to
use a control located in a different model.
•“Placing ActiveX Controls in a Subsystem” on page 4-8 describes how to use
a control located in a subsystem of a model.
•“Placing ActiveX Controls in a Figure Window” on page 4-10 describes how
to use a control embedded in a MATLAB figure window.