User`s guide

DOSLoader Target Setup
4-13
5 Click Create BootDisk.
A message box opens with the following message.
Insert a formatted floppy disk into your host PC disk drive and
click OK to continue.
6 Insert a 3.5 inch disk, and then click OK.
The files
checksum.dat, xpcsgo1.rtb (serial) or xpctgo1.rtb (TCP/IP),
xpcboot.com, and autoexec.bat are copied to the disk.
With
DOSLoader mode, the correct *.rtb file is added to the DOS disk
according to the options specified in the following table.
The numeric value of
n corresponds to the maximum model size. This value
is either 1, 4, or 16 megabytes. The default value for
n is 1, or a 1-megabyte
maximum model size.
Note that the
autoexec.bat file should contain at least the following line:
xpcboot xxx.rtb
where xxx.rtb is the file described in the table above. View this
autoexec.bat file to confirm this.
7 If you want to boot the target PC from the 3.5 inch disk,
a Remove the 3.5 inch disk from the host PC.
b Put that disk into the target PC disk drive.
xPC Target Environment HostTargetComm: RS-232 HostTargetComm: TCP/IP
TargetScope: Disabled xpcston.rtb xpctton.rtb
TargetScope: Enabled xpcsgon.rtb xpctgon.rtb