User`s guide

getxpcenv
14-56
TcpIpTargetPort
Value is 'xxxxx'.
In the xPC Target Explorer window
TcpIp
target port
box, enter a value greater than
20000.
This property is set by default to
22222 and
should not cause any problems. The number is
higher than the reserved area (
telnet, ftp, ...)
and it is only of use on the target PC.
TcpIpSubNetMask
Value is 'xxx.xxx.xxx.xxx'.
In the xPC Target Explorer window
LAN
subnet mask address
text box, enter the
subnet mask of your LAN. Ask your system
administrator for this value.
For example, your subnet mask could be
255.255.255.0.
TcpIpGateway
Value is 'xxx.xxx.xxx.xxx'.
In the xPC Target Explorer window
TcpIp
gateway address
box, enter the IP address for
your gateway. This property is set by default to
255.255.255.255, which means that a gateway
is not used to connect to the target PC.
If you communicate with your target PC from
within a LAN that uses gateways, and your host
and target computers are connected through a
gateway, then you need to enter a value for this
property. If your LAN does not use gateways,
you do not need to change this property. Ask
your system administrator.
Environment Property Description