User`s guide

getxpcenv
14-58
TcpIpTargetISAMemPort
Value is '0xnnnn'.
If you are using an ISA bus Ethernet card, you
must enter values for the properties
TcpIpISAMemPort and TcpIpISAIRQ. The values
of these properties must correspond to the
jumper settings or ROM settings on your ISA
bus Ethernet card.
On your ISA bus card, assign an IRQ and I/O
port base address by moving the jumpers on the
card.
Set the I/O port base address to around 0x300.
If one of these hardware settings leads to a
conflict in your target PC, choose another I/O
port base address and make the corresponding
changes to your jumper settings.
TcpIpTargetISAIRQ
Value is 'n', where n is between 4 and 15.
If you are using an ISA bus Ethernet card, you
must enter values for the properties
TcpIpISAMemPort and TcpIpISAIRQ. The values
of these properties must correspond to the
jumper settings or ROM settings on the ISA-bus
Ethernet card.
On your ISA bus card, assign an IRQ and
I/O-port base address by moving the jumpers on
the card.
The MathWorks recommends setting the IRQ to
5, 10, or
11. If one of these hardware settings
leads to a conflict in your target PC, choose
another IRQ and make the corresponding
changes to your jumper settings.
Environment Property Description