Owner Manual

1. Prepare the panel and frame components
This kit is designed to fit a standard full sheet of lattice or screen panel and will cover an area 8’ x 4’.
Accurately measure the area to be covered by the framed screen. Remember to allow room for the
attachment brackets and screws. If you need to reduce the height and/or width, cut the C-channels
with a hacksaw first, then trim the panel using a wood saw by the same amount.
DRILL 1/8” HOLE 3/16”
FROM EDGE
TRIM MOULDED SCREEN RIB
3/8” FROM EDGE
12”
12”
6”
6”
4’±1/8”
8’±1/8”